HI!
Thanks for the reply!
but here is another thing what i was thinking (could be wrong here though so pardon my ignorance)
One end of my wire is connected to the PCI INTR pin on the PCI slot. the second end is being fed into the FPGA board.
Now what i do not know is where is the PU resistor located. Assuming that PU resistor is actually on the motherboard near the PCI controller , in this case, i am just connecting INTR pin of the PCI card to my FPGA board directly regardless of the PU resistor.
In this case, i do not have to worry at all about the size of the PU resistor.
So assuming that PU resistor is on the motherboard, am i making any sense?
I hope what i said above make sense!
Thanking in anticipation!
cheers!