[SOLVED] Interfacing Xbee and PIC16F877A

[sk8ter87]

Hi guyzz.
i'm doing a project with using xbee..
just want to ask,do i need to set the sender address and receive address in xbee or need to do any programming in pic or vb..
hope you guyz will guide me...
thanks in advance..

 

[Manu.electronics]

Hi guyzz.
i'm doing a project with using xbee..
just want to ask,do i need to set the sender address and receive address in xbee or need to do any programming in pic or vb..
hope you guyz will guide me...
thanks in advance..

No yar ... You dont need any programming ... you just set the address in the Xbee software and connect the module to your controller.......

 

[sk8ter87]

so means everytime time i wanna use this xbee,i need to set the address or i can save it permanently??
can you guide me on this..

 

[Manu.electronics]

so means everytime time i wanna use this xbee,i need to set the address or i can save it permanently??
can you guide me on this..

No No you need to configure at once .. It will work .. Enjoy....

 

[sk8ter87]

No No you need to configure at once .. It will work .. Enjoy....

How do it bro??i'm new to this bro..

 

[elmediel]

We're on the same problem, but I haven't bought a xbee yet. But I think this link will be helpful

XBee Programming Arduino Wirelessly

 

[nandhu015]

Here is the software which i use to check and configure xbee

Knowledge Base Article - X-CTU (XCTU) software - Support - Digi International

This software helps you to set the parameters in xbee module supplied by the manufacturer

 

[sk8ter87]

Thanks nandhu015,elmediel,Manu.electronics..

finally found the the way on how to set the address in xbee..
here is the link of blogspot that help me..hope it will help you guyz..
Microcontroller Projects -- Mohamed Binsad CM: ZigBee Wireless Technology