Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can connect CS to permanent ground, and, as your microcontroller uses INTEL bus timing, don't forget to connect MOT pin to ground .. see picture below ..
Also, it is handy to use IRQ (interrupt) connection between RTC and microcontroller and read seconds (or all time and date memory locations) on interrupt, otherwise you will have to read seconds register all the time ..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.