Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

injecting ac signal into dc one for satellite motor

Status
Not open for further replies.

banner

Member level 1
Joined
Oct 6, 2009
Messages
35
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
iran
Activity points
1,529
Hi,
I want to control a satellite dish motor based on DiSEQC1.2 protocol.
I need to merge a dc signal of 18 volt and a 22KHz pulse of about 0.6v pp. I use linear power supply as DC source and PC sound card as signal source. I have tried T-jucnction with and without an inductor series with Dc power supply and capacitance series with pulse. but it does not work, it degrades the shape of signal. would you please give me a solution?

regards
 

chuckey

Advanced Member level 5
Joined
Dec 26, 2010
Messages
4,863
Helped
1,308
Reputation
2,622
Reaction score
1,281
Trophy points
1,393
Location
Southampton and holiday cottage in Wensleydale (UK
Activity points
31,695
You need either a series resistor across which you put your 22KHZ or an injection transformer. the problem is that if you just try to add them with resistors, the resistors in series with the DC supply will reduce the current to the motor too much. Also the 18V supply will look like a short circuit to the AC. You could overcome this by putting a LF chokke in series with the DC supply.
Frank
 

banner

Member level 1
Joined
Oct 6, 2009
Messages
35
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
iran
Activity points
1,529
Hi
is there any par tnumber for LF choke?
regards
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top