Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
sorry about that.
i follow this circuit but i using 4 4.7uF connect with max232.
max232 tx output is 4.2V, but when i connect to PC serial pin 2 voltage become 0.3V only.
and PC serial pin 3 voltage actually is how much??
i using multimeter measure is -10V when connect with my max232 become -9V is it correct??
i use 2 multimeter to measure same value also too...
could the problem is about the capacitor value??
coz i using 4.7uF.
if i change to 10uF will get different result?
i see display some computer language...
and my code set as (alert, house1, thief break in)
but cant display...
last time i using pic board connect can function...
- - - Updated - - -
i see display some computer language...
and my code set as (alert, house1, thief break in)
but cant display...
last time i using pic board connect can function...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.