srijan.rio
Member level 2
Hi everyone. While generating the results for the efficiency and the power of the transmitter and receiver separately for a Wireless power transfer system, the ratio of power(i.e. efficiency) is coming inconsistent.
I have posted a picture of what is going wrong.
The ratio of the magnitude is coming different than what it should be for the actual magnitudes. Is it a bug or am I doing something wrong .?
- - - Updated - - -
Ok I have figured out where I was going wrong. The voltage source in Simplorer has different tab for AC parameters and I didn't specify the AC parameters properly for the AC simulation. Hence the inconsistency. Now its coming fine
I have posted a picture of what is going wrong.
The ratio of the magnitude is coming different than what it should be for the actual magnitudes. Is it a bug or am I doing something wrong .?
- - - Updated - - -
Ok I have figured out where I was going wrong. The voltage source in Simplorer has different tab for AC parameters and I didn't specify the AC parameters properly for the AC simulation. Hence the inconsistency. Now its coming fine