Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
as far as i know you need a service terminal for this and than you have to reset parameter 69. that was the procedure several years ago. maybe there is a program for a pc or laptop to do this nowadays.
i figured out you can also knock out the LED. or cut out resistor 78 (?) on the main board.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.