Importing TANGO SCH to ACCEL EDA: missing components

[jtcost]

Hi folks,

ive tring import TANGO SCH to EDA and all wires and connections are successful translate except the component (parts)
All components are missing.... Any tip or advice to do this work as well?

THX in advance!

 

[dick_freebird]

Not knowing the intermediate steps (and probably not having
much good idea about their details anyway), I'd suggest:

- Look at what the process is to bring across the library
device symbols - is it done at all, is the result in some odd
place just waiting to be hooked up, is it a separate action
to create the target library for Accel, is it doable at all?

- If this is all a bucket o' fail, then you may have to create
the library by hand (slog, slog).

- If the tool1-tool2 path is not clean, maybe there is another
tool that has better-greased paths in/out of the two endpoints
than either has for the other, directly.

- Is there perhaps an Accel library pre-existing, that only needs
you to enter / copy / modify instance properties (incl lib & name)
to get the circuit back? Like, "npn" might stand a good chance
of having consistent properties and maybe even pin-grid).