Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
if i have to include a normal lumped resistor in microstrip structure how do i proceed...could u tell me the steps plz....dat would be really helpful.....
In mgrid add two local ports at the place of resistor. Simulate it. open modua. add the simulated results block in modua and add resistor to the appropriate port. re simulate in modua.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.