Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am building a mobile robot nowadays, and i am thinking of infrared transceiver so do i need to send the pulses in a specific frequency or it does not matter?
I think if you are using an IR receiver module(like one in TVs, dish receiver), you'll need to send the IR signal at 38KHz cause these recevers won't work except at this frequency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
