Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this servo needes 1ms to 2ms pulse for moving zero position to 90 degree.u can generate these pulse ur self with pic controller.
generate 1ms high and 19 ms low for zero position and for 90 degree 2ms high and 18ms low.for center position of servo 1.5ms high and 18.5ms low pulse.
this servo needes 1ms to 2ms pulse for moving zero position to 90 degree.u can generate these pulse ur self with pic controller.
generate 1ms high and 19 ms low for zero position and for 90 degree 2ms high and 18ms low.for center position of servo 1.5ms high and 18.5ms low pulse.
Is easy. Initialize a timer and with it control the high level time and low level time. The servo goes to a fixed angle depending on the relation between this two times.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
