Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

i need power schottky diode

Status
Not open for further replies.

niks

Full Member level 3
Full Member level 3
Joined
Mar 18, 2002
Messages
189
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
1,386
what is vrr for diode

i need on High Voltage schottky Power Rectifier
a) Vforward drop (Vf<=0.75)
b) Forware Current (If=<=1A)
c) Reverse Recovery Voltage ( >120V)
d) package (SMD).
 

Roel

Member level 2
Member level 2
Joined
Dec 17, 2002
Messages
45
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Belgium
Activity points
359
Scottky Power diodes

See the MBRS-series from Fairchild and ONsemi.

Example: MBRS140: 40v reverse voltage, 1 Amp, SMB package

I don't know if they have diodes up to 120Volt. Have a look at it.

Roel
 

layoutdude

Junior Member level 3
Junior Member level 3
Joined
Feb 21, 2002
Messages
27
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
206
Also have a look ar International Rectifier

www.irf.com

I have used *many* diodes with VRR > 150 V and If > 10 Amps

Your Vf will probably be lower because of your low forward current.

For example p/n 10CTQ150 is right around 0.75 volts @ 1 amp @ 25 C (rated at 0.93 volts @ 10 amps)
 

niks

Full Member level 3
Full Member level 3
Joined
Mar 18, 2002
Messages
189
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
1,386
need small package

thanx for the reply. but i need small packages . Just now i have STPS1H100A i.e. SMA package. i smaller or slightly bigger package.im very much concern about the area.
regards
~niks~
 

mystery

Full Member level 2
Full Member level 2
Joined
May 9, 2001
Messages
124
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,298
Location
Turkey
Activity points
825
you may also look at microsemi products
 

penrico

Full Member level 5
Full Member level 5
Joined
Aug 28, 2001
Messages
286
Helped
27
Reputation
54
Reaction score
8
Trophy points
1,298
Location
Argentina
Activity points
2,393
There is Diodes from Panjit too, S100 for example.
 

niks

Full Member level 3
Full Member level 3
Joined
Mar 18, 2002
Messages
189
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
1,386
hi
i checked all the sites but maximum Vrrm = 100V in SMD package. i want SMD (SMA preferably), Vrrm > 120
regards
~niks~
 

penrico

Full Member level 5
Full Member level 5
Joined
Aug 28, 2001
Messages
286
Helped
27
Reputation
54
Reaction score
8
Trophy points
1,298
Location
Argentina
Activity points
2,393
If you need Vrms>120v and you have 100v, and Vf<0,75v, you can connect serialy two 100v schotkly diodes, you may equalizate boths diodes using resistors.


Diode Resistor Diode Resistor
----|>-----/\/\/\/\------|>-------/\/\/\/\-----

To calculate resistor value, use the maximun current of circuit, remember that schotkly diode is Vf=0,3 to 0,4v.

it help :?:
 

layoutdude

Junior Member level 3
Junior Member level 3
Joined
Feb 21, 2002
Messages
27
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
206
I think you are asking for too much.

Consider the power in the part is going to be at least 0.75 watts (Vf * If), which is probably too much for a small package like SMA (SMB or SMC more likely, even better to use DPAK).

Best of luck, but I think you are going to have a difficult time locating anything.
 

niks

Full Member level 3
Full Member level 3
Joined
Mar 18, 2002
Messages
189
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
1,386
yes my design is having critical requirement.
i got one. BAT240A from Infineon.
 

pool_77

Full Member level 3
Full Member level 3
Joined
Aug 8, 2001
Messages
183
Helped
5
Reputation
8
Reaction score
3
Trophy points
1,298
Location
EU
Activity points
1,267
What about to use FET as a diode

pool_77
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top