Dear all,
I've downloaded the FPGA design tool, ISE 11, from Xilinx web site
because they offer 30 days evaluation. I madethe following steps to install and run the ISE 11 tool:
1- Using the shell, I pointed to the location where the installation is located /home/Sameh/Ise_src
2- I typed ./xsetup, the the setup window appeard (I was so happy at this point)
3- The installation needed only 8 seconds to complete showing the message"Installtion complete"
4- I finally write in the shell "ise" from /Xilinx, but nothing happens "bash: command not found"
Please can you tell me what did I do wrong. I need explanation because I read the installtion relase notes
from Xilinx home "irn.pdf" and it wasn't helpful.
Bytheway, my kernel version is 2.6.x
Many thanks,
Sameh Yassin