Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

HT9200B DTMF generator INTERFACING TO TELEPHONE LINE

Status
Not open for further replies.

mc004

Newbie level 3
Newbie level 3
Joined
May 29, 2006
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,307
ht9200b

I design DTMF generator with HT9200B. But how can I interface the output of the HT9200 device to the telephone line? there is a schematic in HOLTEK web site.(**broken link removed** ) But there are 3 undefined transistor. What kind of transistors must be used in this circuits. thanks.
 

dtmf generator

This circuit from your link looks "suspicious" ..
Here is a circuit that works .. see picture below ..

Regards,
IanP
 
  • Like
Reactions: tpetar

    tpetar

    Points: 2
    Helpful Answer Positive Rating
ht9200 fail

I had the same problem. I hope IanP's solution works... Anyone tried it already?[/quote]
 

hardware dtmf generator

PNP - 2N5401,
NPN - 2N5551
 
  • Like
Reactions: davehj

    davehj

    Points: 2
    Helpful Answer Positive Rating
ht-9200b

hi

NPN 2n5551 is ok
PNP 2n5404 or mpsa92 (U can use)
 
  • Like
Reactions: davehj

    davehj

    Points: 2
    Helpful Answer Positive Rating
dtmf generator circuit

One transistor is MPSA92, the other one is MPSA42 and both of them MUST use high voltage type transistors. Otherwise the NPN transistor will switches on when ring signal applies to it, as a result the isolation fails.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top