hfr002
Newbie level 1
Hi,
I am working on a Mixer and LNA postlayout simulation. The layout includes the bonding pads and some decoupling capacitors. The total area is 1sqmm approx. I am using Hspice RF for the simulation and the commands HB to obtain the P1dB, IIP3, and NF.
Hspice will run until the following message:
hb residual = 5.656854e-001
Error: Out of memory (used = 0.0 Mbytes, requested = 65.6608 Mbytes).
I have increased the virtual memory of Windows Xp usings Xp's own virtual memory administration tool, but it seems that Hspice does not recognice the newly allocated memory.
Does somebody know a procedure to increase the memory allocated to Hspice?
Thanks
Hugo
I am working on a Mixer and LNA postlayout simulation. The layout includes the bonding pads and some decoupling capacitors. The total area is 1sqmm approx. I am using Hspice RF for the simulation and the commands HB to obtain the P1dB, IIP3, and NF.
Hspice will run until the following message:
hb residual = 5.656854e-001
Error: Out of memory (used = 0.0 Mbytes, requested = 65.6608 Mbytes).
I have increased the virtual memory of Windows Xp usings Xp's own virtual memory administration tool, but it seems that Hspice does not recognice the newly allocated memory.
Does somebody know a procedure to increase the memory allocated to Hspice?
Thanks
Hugo