Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[HSPICE] Need to read already present tr0/fsdb

Status
Not open for further replies.
I

INS-ANI

Full Member level 3
Full Member level 3
Joined
Feb 28, 2007
Messages
152
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,298
Visit site
Activity points
2,377
Hi,

I have already run a lengthy simulation and have the tr0/fsdb ready.
Now, please consider following requirements:

1) I have to run few .measure commands for this simulation, but i don't want to re-run the simulation again. Using HSPICE/XA or any other tool can I run my .measure commands on existing simulation dump?

2) I have a random time point (say 5n ) , I have to generate a log file which details voltage on each nodes at 5ns. is there any hspice command which can dump these values?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top