Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HSPICE .ic not working

Status
Not open for further replies.
H

harry_croft84

Newbie level 3
Newbie level 3
Joined
Aug 24, 2007
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,309
I try to set initial condition(.ic) for my hspice simulation but nothing happen.

I have try using .nodeset, also not working. any advice.

.ic v(xlab.x1401b.xle0.xlecram0.xr120.n1) = 0
 

Have you included the UIC option to the TRAN statement ("use initial conditions")?

Nodeset is different and the voltages will be released BEFORE the initial bias point calculation. While that can force a bistable circuit into a particular state it does not influence the bias point calculation in the same way.

Keith
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top