Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

HSPICE/Display SPICE model parameter for a run

Status
Not open for further replies.

gurunath.kadam

Newbie level 6
Joined
May 3, 2011
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Darmstadt, Germany
Activity points
1,366
Hi,

I am relatively new to HSPICE. I am trying to run some corner analyses on a small RO circuit.

Some SPICE models used in the set up have some complicated equations against them sometimes few variables referencing through different files (to model the dependencies on various factors). I need to print these values against each corner for selected variables. Can I do this?

For eg. mobility parameter UO might be varying from TT -> FF for each type of MOS. Can I print this parameter for each MOS (N and P type) for each corner? If yes, how?

Thank you!

-Guru
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top