Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to use the JTAG port for MIPS (IDT)?

Status
Not open for further replies.
P

priyaphule

Junior Member level 1
Junior Member level 1
Joined
Jun 7, 2005
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,436
Please tell how to use the JTAG PORT (only JTAG not EJTAG).

I am trying to use the only the system controller of the IDT but the wiggler (same used for the ARM7)does enter into the debug mode after connection establishment.

What must be the pinouts for the JTAG? Is there any hardware pin to be used to go to the debug mode(as such RTCK in the ARM7 core)?

Presently using following pins:
1. EJTAG_TMS
2. JTAG_TCK
3. NC
4. JTAG_TRST
5. JTAG_TDI
6. JTAG_TDO
7. GND
8. VCC

AND JTAG_TMS is grounded.
I am not sure about the EJTAG_RST pin.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top