Hi, enjoyed the detailed explanation above on brazing. I have a question going in the reverse direction. How do you unsolder or unbraze a silver-soldered joint between stainless steel and brass without destroying optical components housed within?
induction heating
car battery a resistor made from an old electric fire spring wire flap over a few times i use the same method to make a dummy load for audio p.a work {fold till its 8R or 4R but i think you can use a crock clip to adjust it and put it somewhere safe like back in its glass tube }
and two contacts made from the shape needed for the job some flat bars or points etc
for cleaning solder while its hot use a piece of mole skin hide to clean off heavy solder deposits you may need to tidy using a small pcb blowtorch seen a few models of this type or a blob of wirewool from a fine lathe that has been sprayed with flux and made into a small pad 1" on a stick
I don't know the answer to your question but I want to make a guess. Are you want information about brazing so you can go my link Induction Brazing thanks