Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to un-selected device in cadence?

Status
Not open for further replies.

VoltarGomes

Newbie
Joined
Nov 21, 2020
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
27
Hi,

For simulation, some times we do not want certain symbol/device on the schematic to simulate for this time, but later we will still need them. For this 1st time simulation, we have to remove it or bypass it, and then start to simulate.

Anyone knows that how to we un-selected the unwanted symbol/device to make sure that the simulator does not extract their netlist, but the symbol/device is still on the schematic? ADS and simulink has such comment/ uncomment function.

Thanks,
 

dick_freebird

Advanced Member level 5
Joined
Mar 4, 2008
Messages
8,119
Helped
2,272
Reputation
4,554
Reaction score
2,293
Trophy points
1,393
Location
USA
Activity points
64,909
Nothing straightforward that I know of.

If you had a "dummy" view (one with pins
but no "guts") than, if you started from a
config view (hierarchy editor) then you
would have ability to select view type per
instance or per master and could force
specific devices to netlist "null".
 

VoltarGomes

Newbie
Joined
Nov 21, 2020
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
27
Hi,

For simulation, some times we do not want certain symbol/device on the schematic to simulate for this time, but later we will still need them. For this 1st time essay writer simulation, we have to remove it or bypass it, and then start to simulate.

Anyone knows that how to we un-selected the unwanted symbol/device to make sure that the simulator does not extract their netlist, but the symbol/device is still on the schematic? ADS and simulink has such comment/ uncomment function.

Thanks,
thank you my issue has been solved
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top