amin amin
Newbie
I am currently designing a 10 loop antenna (110Mhz) (radius of the wire /1.4mm height of the coil 3cm /radius of the loop 4.5cm) after running the simulation I got this error:
The mesh near the lumped element "2" seems to be corrupted. Please simplify the model if possible, or consider thickening adjacent lossy metal sheets. Also note that the element must not pass through PEC or lossy metal.
How to solve this error?
The mesh near the lumped element "2" seems to be corrupted. Please simplify the model if possible, or consider thickening adjacent lossy metal sheets. Also note that the element must not pass through PEC or lossy metal.
How to solve this error?