Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Go to "sweep setup *" and set "COUPLED CH" to "Off". Then go to "power *" and set "PORT POWER" and "CHAN POWER" to "UNCOUPLED". You should be able to set two different power levels now.
* These are under the stimulus box on the analyzer
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.