Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to run DFT for both async reset and set circuit

Status
Not open for further replies.

tigerajs

Member level 3
Member level 3
Joined
Feb 8, 2006
Messages
55
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,638
what is the command for Synopsys DFT
 

During synthesis you need to replace flops with scan flops, define DFT architecture, check drcs , insert test points and then connect the scan chain.

Its a little more complex than what I mentioned. Hope this gives you some overview of DFT insertion.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top