Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to remove the nets for power source and ground connections in Orcad layout?

Status
Not open for further replies.
R

Rahul Aggarwal

Newbie level 5
Joined
Aug 7, 2011
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,348
Hi,

I am making a 4 layer board in orcad(2-routing and 2-plane layers),but the problem i am facing is even when i have assignes layers for power and ground connections then also orcad is routing those connections and making it messy.
What should i do in order to remove the nets connecting all the power source connections and all the ground connections and restricted them to plane layers only.

PS-i am just a beginner to orcad.

Please give some good suggestions and i'll really appreciate it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top