capital_zach
Junior Member level 3
Hi guys,
I have a square wave that have a dc offset approximately 1.5V. The frequency of this square wave is 10kHz. I've read that I can remove the DC offset by using high pass. My question is, what values should R and C have so that I can get a square wave with dc bias = 0V?
I have a square wave that have a dc offset approximately 1.5V. The frequency of this square wave is 10kHz. I've read that I can remove the DC offset by using high pass. My question is, what values should R and C have so that I can get a square wave with dc bias = 0V?