yemi11
Newbie level 4
i would like see the transient response of dc motor.
if i apply 24v to circuit, than take 2 wire from motor pins,
what should i do with this pins ?
1) i want ta connect them to the analog input of microcontroler and it can only measure 0-5 V..
2) the things that i will do to measurement wires shouldn't effect the motor circuit of course..
if i design a voltage divider with a "very very high" resistors is it works ?
or any other solution do you have ?
if i apply 24v to circuit, than take 2 wire from motor pins,
what should i do with this pins ?
1) i want ta connect them to the analog input of microcontroler and it can only measure 0-5 V..
2) the things that i will do to measurement wires shouldn't effect the motor circuit of course..
if i design a voltage divider with a "very very high" resistors is it works ?
or any other solution do you have ?