Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to reduce the height of Vertical Border line using ORIGINPRO7

Status
Not open for further replies.

raju_kambar

Full Member level 3
Joined
Jun 19, 2013
Messages
153
Helped
5
Reputation
10
Reaction score
5
Trophy points
18
Location
Earth
Activity points
1,404
I am using ORIGINPRO7 for drawing my research graphs. I have drawn two columns and single row using ORIGINPRO7. I want to reduce the height of VERTICAL lines of two columns using ORIGINPRO7 and retaining same horizontal length. What option I have to use for reducing the height of the VERTICAL line. Can you advice me. I have shown below screen shot of ORIGIN generated two columns and single row.
 

Attachments

  • Verticle_Height_Reducing_in_ORIGINPRO_7.jpg
    Verticle_Height_Reducing_in_ORIGINPRO_7.jpg
    1.1 MB · Views: 6

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top