I am a beginer, so if anybody know how to programming for TMS320F28x withou using XDS510/560, could you show me ??? (more cheap, more better)
Mail to: vienthong@visl.gov.vn
Thank you very much ! Happy new year !
if you program via RS232, you need only a simple serial cable, and a 3.3V RS232 interface (max3232) in the DSPs board.
And you have to hack some files... it is written in the documentation of the RS232 patch.
you need:
-SD emulation drivers
-TI flash algorithms 4.x
-RS232 patch.
Could you send me:
-SD emulation drivers ???
-TI flash algorithms 4.x ???
-RS232 fix. ???
Could you give me your Email ???Mail to : vienthong@visl.gov.vn
Thank you very much !
I am a beginer, so if anybody know how to programming for TMS320F28x withou using XDS510/560, could you show me ??? (more cheap, more better)
Mail to: vienthong(at)visl.gov.vn
Thank you very much ! Happy new year !
Hi!
I worked with taht DSP a year ago, using Code Composer Studio with DSP/BIOS to do my code and my PC parallel port.
Header files, emulators, code examples, etc, are avaiable in TI.
By the way, be careful with versions. There is a memory mapping incompatibility between newer versions of software and past ones.
Hi
I am also using TMs320f2812 dsp controller.
TI gives jtag pins for PC interface ,
i have seen in starterkitEZdspf2812 thay interfaced DSP chip with Jtagto Parellel port interface.
I have a confusion cant we direct interface USB port to DSP f2812. or always we need some mediater IC for converting JTAG to USB/Seriel/parellel(for cheap solution)
i got stuck at this point .
Can you help.
maybe through a FIFO memory. put the FIFO onto the systembus. the other port of the fifo goes to the codec. this is single directional. you need a clock-oscillator as well.