Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to program .HEX file using Pickit3 + MPLABX without recompiling ?

Status
Not open for further replies.
A

asking

Full Member level 5
Joined
Sep 21, 2010
Messages
279
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,298
Activity points
3,377
Hello,
I have just received my PicKit3 and i m unable to program already made .HEX file from MikroC to the programmer ? When i try to click on Make and Program Device Main Project it tries to compile it again using Hi-Tech C Compiler and the reason is i m not able to download the hex file to my PIC MCU. Hex File is ready...please show me some suggestion how to directly program without recompiling ? it ?
 

I am not sure about MPLABX, but with MPLAB you go to "File | Import" to load the hex file (with no project open).

Keith
 

Ok.. I have tried using IPE v1.6 and I was able to program pic mcu. Successfully.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top