truebs
Full Member level 5
Hello friends ,
i've designed a system which in short is :
A tx and a rx ,the rx sends binary data to tx,when i press a button at rx end (i.e like remote control ).
Now i want that my circuit should send data automatically to tx,if it is in the range of the tx.
How can i do it ?
point to consider is:-
1. signal from tx are quite low in power.
Any suggestions ,links, methods, would be encouraged and thanked !
Thanks !
i've designed a system which in short is :
A tx and a rx ,the rx sends binary data to tx,when i press a button at rx end (i.e like remote control ).
Now i want that my circuit should send data automatically to tx,if it is in the range of the tx.
How can i do it ?
point to consider is:-
1. signal from tx are quite low in power.
Any suggestions ,links, methods, would be encouraged and thanked !
Thanks !