There's basically only one method. Setting I0 and I1.
Hi FvM,
When I1 < 700nA, M2 goes into breakdown mode.
When I1 is In between 1uA and 700nA (inclusive of the limits), M2 is in subthreshold mode.
When I0 > 1.5mA, M0 is in Saturation region except for 0-400mv.
0<Vd<=400mv, M0 is in triode region. From 400mV onwards, M0 goes into sat region.
I tried varying I0 till 2.5mA, I observed the same behaviour.
How can I make M0 in Sat region from 0<= Vd <= 1.8V? I varied I0 for the wider range. But I observed that until 300mV, M0 is in triode region.
The circuit is designed to behave as an active inductor.
Can you please let me know how to proceed further?
I want to operate the circuit such that M0 is in Sat and M1 is in Sub threshold region.
Till now, I did dc analysis.
Whatever behavior I have observed is the expected one? Any correction is required in the procedure?
Please help me out.
Can someone help me out pls?
PS: With the above values of current sources, I can see only the real part of impedence. I don't see any imaginary part when I plot a graph impedence Vs Voltage. What should I do inorder to see the imaginary part of the impedence? I am indesperate need of help and its very urgent for me.