Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can go to Edit > Properties of the board > Board Settings and can set layer pairs to 1. This means you have Copper Top and Copper Bottom to route the signals. You can use Copper bottom.
As for the libraries, I guess you can do one of the following,
1. create the footprint for the new part using the Component Wizard
2. copy existing footprint from ultiboard master library to user library and edit it it to meet your requirements.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.