Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to make a PCB in Protel ?

Status
Not open for further replies.

ebi82

Newbie level 3
Joined
Oct 9, 2007
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,306
hi. iwant to know about how i can to make pcb in protel .if any body know plesea help me
 

hassenman

Advanced Member level 4
Joined
Nov 29, 2004
Messages
117
Helped
4
Reputation
8
Reaction score
1
Trophy points
1,298
Activity points
912
Re: pcb in protel

Hi ebi82,
Once you're finished with creating the schematics, you have to :

1- Annotate your components {Tools → Annotate} , u click Update changes, then Accept changes. (figure-1).

2- A new window shows up, u click Execute changes, then close. and after that save your schematics. (figure-2).

Now you have created the NetList, and you can begin your PCB.

3- Create a new PCB (figure-3).

4- Configure your board options {design → board options}, u can configure measurement unit, snap grid . . . (figure-4).

5- Define the board's shape {Design → Board Shape → Redefine Board Shape}. (figure-5).

6- Now, u can import the netlist u already created { Design → Import Changes From <Your Pcb name>}. (figure-6).

7- Finally u can place your components and then route them.

Hope it helps.
Regards,
Hassen.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top