This device is the control card for iFlex E5 overhead crane. This is not working now. We discussed with supplier. after 3 months of several conversation, they are offering two things: We can replace it by a new one which will cost USD 30K, or they can send the program and we need to load it to the controller. Also we paid them some for program (over 2000). But now they are not telling how to program.
But as the crane is not running, so per day loss is: $500.
So we oped it, and found there is lots of ICs most of them are different kind of shift registers, power controller, smps driver, opto-couplers, etc. Only one central chip is Actel FPGA. and a block of chips is just over that FPGA and most of the connections are going to that FPGA. That is why I asked if it is programmable or not. If so then how to load the program. I think now you got a clear idea.