Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to load .hex file in avr atmel board using linux

Is it a bad post? I want to know as I am a newbie

  • Good

    Votes: 0 0.0%
  • Bad

    Votes: 0 0.0%
  • OK

    Votes: 0 0.0%

  • Total voters
    0
Status
Not open for further replies.

mukul

Junior Member level 3
Joined
Jun 27, 2004
Messages
25
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,283
Location
India
Activity points
145
I am new to microcontroller programming
I have made hex file of my .c file from gcc crosscompiler but finding error
to flash .hex file in AVR Kit.

tell me that Which kernel version is required for uisp and gcc
and the sequence of command used.
I don't know y uisp is required to install but i know that it is necessary
The final command to load file I am using is
make flash
as far as I remember but it is showing error.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top