Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to include .EBD model in Hyperlynx

Status
Not open for further replies.
S

SughiRam P.

Member level 2
Joined
May 26, 2011
Messages
52
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,288
Location
INDIA
Activity points
1,610
Hi Experts,

I have EBD model of a DIMM module, IBIS model of a Processor and S-parameter model for a DIMM connector. I'm going to do Pre-route SI analysis. e.g. For Address signal, Processor will drive the signal via DIMM connector to DDR device in DIMM module.
I can able to include IBIS model of a processor and S parameter model for DIMM connector in linesim. But, I don't know the procedure to add EBD model file of a DIMM module to proceed with simulation. Can anyone share the procedure to include add EBD model file in linesim???
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top