I have designed a CMOS class-E switching power amplifier in cadence for that how can i found my input,output power and gain of my amplifier for that what analysis I should do.
There are couple of options, first you can try harmonic balance (hb) where you place a ports at the input and at the output of the amplifier . In this non-linear simulation you get the voltage at each harmonic, and the fundamental Vout/Vin is the gain voltage or power assuming the same impedance.
You can always run transient and calculate the harmonics via FFT.
Yes I run transient in that my input is in milli volt but my out put is in micro volt why the signal is not getting amplified is there any other thing to do in that?
Yes I run transient in that my input is in milli volt but my out put is in micro volt why the signal is not getting amplified is there any other thing to do in that?