chensy
Newbie level 2
Because the project needs a high bandwidth, the use of network card binding method. Network card eth0 and eth2 connected to the exchange chip 2.5G port, the other port system, the rate of 1G;
Eth0 and eth2 the actual test up to 1.2G, the need to achieve through the network card binding 1.6G.
Card binding, switching chip port binding are done, but the test bandwidth of up to 1.4G, far below the requirements.
Has anyone done a similar test?
Eth0 and eth2 the actual test up to 1.2G, the need to achieve through the network card binding 1.6G.
Card binding, switching chip port binding are done, but the test bandwidth of up to 1.4G, far below the requirements.
Has anyone done a similar test?
