how to design a cmfb(two stage fully differential amplifier)

Status
Not open for further replies.
Z

zhutiancheng

Newbie level 4
Joined
Mar 29, 2006
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,333
2 stage differential amplifier

I want design a two stage fully differential amplifier which is applied to SC circuit. But I found that the circuit didn't work when i use one common cmfb circuit. I don't know how to design a cmfb to fit it. if who know some structures can solve the promble, please give me some advise. thanks!
 

two stage differential amplifier

if u design for two stage OTA, you need try to use two cmfb for each stage
 

two stage cmfb


Try to use continuous time CMFB firstly, if the cointinuous time CMFB is correct then replace the resistor with switched capacitor. It is to be noted that the feedback must be negative. Don't connect it as a positive feedback!
sixth
 

cmfb design

It is recomanded to apply Switch-Cap CMFB instead of C-T CMFB. Ken Martin's book should be a good reference.
 

differential amplifiers 2-stage

no, only one cmfb circuit can serve stable common voltage for two stage opamp.

noiseless said:
if u design for two stage OTA, you need try to use two cmfb for each stage
Click to expand...
 

two stage opamp cmfb

I know that two cmfb can solve the problem.but in that case, i must add a transistor in the second stage. i want to use one cmfb, but don't know how to turn the feekback to negative one.
 

2 stages differential amplifier

well,
negative feedback means that if the OP output voltage is larger, the CMFB circuit will increase OP's current to make OP's output decrease. So, first of all, you must confirm this point.
The way of Mr./Ms sixth is right , and another way is writing an expression of controlled voltage witch is helpful for your simulation.
 

differential amplifier twostage

the attached file show you full different two satge opamp use only one cmfb, it from gray's book.

 
differential amplifier 2 stage

hello ,
i have a question how vb1 is obtained , i think it needs another cmfb circuit,
check this for getting what i meant
 

two stage differential amplifiers

no, vb1 is just a active load bias, no need to cmfb
the paper your refer need second stage cmfb bacause it is class AB output, if only class A output as this schematic, it need not second cmfb, also you cna refer chapter 12 of gray's book.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…