rinox
Newbie level 5
Hi,
I searched in previous forum topics and noticed that there were some discussions about this problem but no one explains completely the solution.
I managed to simulate non-homogeneous offset stripline structures in CST but with Discrete ports only. I tried to define Waveguide ports but the results are not reasonable.
My structure looks like following:
///////GND////////
Er1=3.54; h=0.101mm
----------------- stripline (0.11mm width as 50Ohm for 11.725GHz)
Er2=3.48; h=0.762mm
///////GND////////
Length of the stripline can be lambda/4 and 2 ports are defined at the edges of the structure.
Does anyone have experience in defining waveguide ports in CST for such structures?
Would be appreciated any reply.
rinox
I searched in previous forum topics and noticed that there were some discussions about this problem but no one explains completely the solution.
I managed to simulate non-homogeneous offset stripline structures in CST but with Discrete ports only. I tried to define Waveguide ports but the results are not reasonable.
My structure looks like following:
///////GND////////
Er1=3.54; h=0.101mm
----------------- stripline (0.11mm width as 50Ohm for 11.725GHz)
Er2=3.48; h=0.762mm
///////GND////////
Length of the stripline can be lambda/4 and 2 ports are defined at the edges of the structure.
Does anyone have experience in defining waveguide ports in CST for such structures?
Would be appreciated any reply.
rinox