pfng
Newbie level 2
Hi,
I have some questions regarding Assura LVS/RCX.
1) How to debug Assura LVS? To debug DIVA extraction, I used to use saveDerived and view the layer in the extracted view. But Assura there is no extracted view, so how to go about debugging?
2) Can I run LVS after RCX? This is to check if the extracted netlist with parasitics is well form. I had experience that the parasitic resistor is shorted to ground, drawing a lot of current.
3) My Assura LVS recognise resistors with the 2 terminals connected to the same terminal as malform devices. Why? How to by pass this?
Please advice.
I have some questions regarding Assura LVS/RCX.
1) How to debug Assura LVS? To debug DIVA extraction, I used to use saveDerived and view the layer in the extracted view. But Assura there is no extracted view, so how to go about debugging?
2) Can I run LVS after RCX? This is to check if the extracted netlist with parasitics is well form. I had experience that the parasitic resistor is shorted to ground, drawing a lot of current.
3) My Assura LVS recognise resistors with the 2 terminals connected to the same terminal as malform devices. Why? How to by pass this?
Please advice.