MissP
Newbie level 1
Hi everyone
I am trying to connect my gsm to PC hyperterminal and send AT commands,but I dont get any response.on the hyperterminal (at the bottom bar where is shows the duration of connection),it shows Autodetect,not the baute rate,but when i connect the PIC18f452 to PC i am able to see the baute rate.
Is there any configuration or any special connection i must do between the gsm and the PC?
Thanks
---------- Post added at 11:50 ---------- Previous post was at 11:48 ----------
The module is GE864-PY not GE684-PY
I am trying to connect my gsm to PC hyperterminal and send AT commands,but I dont get any response.on the hyperterminal (at the bottom bar where is shows the duration of connection),it shows Autodetect,not the baute rate,but when i connect the PIC18f452 to PC i am able to see the baute rate.
Is there any configuration or any special connection i must do between the gsm and the PC?
Thanks
---------- Post added at 11:50 ---------- Previous post was at 11:48 ----------
The module is GE864-PY not GE684-PY