Mr.Cool
Advanced Member level 2
i am simulating a DC to DC converter using simulink. i have voltage sensing on the converter output which i run through a simple controller, PI feedback system.
when i set my Kp (gain) from 0.2 to 0.8 the simulation just craps out!
the solver i am using is 23T
then, i change the solver to a different one and if i select a "good" one i get a simulation!
why the 23T vsolver crap out on me?
Mr.Cool
when i set my Kp (gain) from 0.2 to 0.8 the simulation just craps out!
the solver i am using is 23T
then, i change the solver to a different one and if i select a "good" one i get a simulation!
why the 23T vsolver crap out on me?
Mr.Cool