In designing circuit, do we calculate Ic using β or using the V=IR because in book which im currently studying, all the calculation are using β to calculate Ic but if β is 50 and then the Ic is different right?
Well Ib=(V1-Vbe)/R1=(10V-0.65V)/100KΩ≈93.5uA
If BJT work in active region Ic is equal Ic=Ib*β=93.5uA*β
So if our BJT has β=60 Ic will by Ic=93.5uA*60=5.61mA. But if our bjt has β=100 then Ic=9.35mA and transistor will be working in saturation region. Because Icmax=V1/R2=10mA
Hmm, You know in a real word Ic will still have different value then it is in the simulation. Because we don't know the β of a 2N4014 we can only assume that β is smaller or equal 70.
In you're simulation the BJT is in saturation region because the β is larger the 100 and in the saturation the Ic=Ib*β don't hold anymore
In saturation Ic=(Vcc-vce(sat))/Rc
And that's why we use this circuit only as a switch.
If we want a linear amplifier we use this circuit https://upload.wikimedia.org/wikipedia/commons/2/27/Common_Emitter_amplifier.png Ic=[β*(Et-Vbe)]/(Rb+(β+1)*R4) Et=[R2/(R1+R2)]*Vcc Rb=R1||R2 || - parallel Rb=(R1*R2)/(R1+R2)
And assume that Ic=1mA; Vcc=10V;β=70 and VR4=1V VR3=(Vcc-VR4)/2=4.5V. R3=4.5V/1mA=4.5K=4.7KΩ R4=1V/1mA=1KΩ R2=(VR4+Vbe)/(Iz)=5.1KΩ Iz=5...30*(Ic/β) R1=(Vcc-Vbe-VR4)/(Iz+Ib)=24KΩ
check this values in the simulation
Yes, in most cases. The purpose of the circuit hasn't been mentioned at all. So we don't even know, if saturation is intended (for a switch) or shall be avoided (for a linear amplifier). In the latter case, you probably try to achieve a particular operating point, but you didn't tell.
It didn't come clear, why Multisim uses the maximum current gain for 2N4014 rather than a typical value. But it's O.K. in so far, as a current gain of this size has to be considered. To check the circuit stability against parameter variations, the complete min to max range should be tested. Then the measures mentioned by Audioguru get important.
β, by the way, is usually the symbol for the small signal current gain and not identical to large signal value B, that is determining the operation point, altough the difference may be neglected in a rough estimation.
I am pretty sure you are confused now about all the formulat stuff.
Therefore, my recommendation:
At first, you should always have in your mind that transistor circuits are non-linear circuits - with the consequence that you carefully have to discriminate between static and dynamic (differential) resistances. Your circuit is a mixture of both - resistor as separate parts are static, but transistor pathes (for exampe between base and emitter) exhibit dynamic resistances. Therefore, you need characteristic curves from the data sheet for computing currents and voltages - or you can make suitable assumptions because some parameters are typical for all transistors.
As an example - to assume app. 0.7 volts between base and emitter for normal transistor operation as an amplifier.
And realize - perhaps with the help of a simplified transistor equivalent circuit diagram - that the transistor acts like a voltage controlled current source .
Without these basic considerations you cannot understand and analyze transistor circuits.