wtr
Full Member level 5
Hello all,
I using the kintex 7 gt wizard setup with 8/10b ethernet so I can see the destination & source mac address.
The fpga works with a loop back etc.
The problem I have is when i connect it to a network card. The external network card does not recognize it.
I guess this is due to a layer 2 auto negotiation problem.
Is it possible to do a build with the pcs and pma ethernet module which allows me to filter based on source and destination mac? In addition will i get a strobe if it fails these values?
otherwise I'm forced to have to use the gt wizard and monitor the rxischar/rxiscomma signals until I get the correct sequence.
Now first things first.
How do I get an external network card to acknowledge there is a carrier?
Do I state machine a auto negotiation sequence or do I configure the network card?
REgards,
Wesley
I using the kintex 7 gt wizard setup with 8/10b ethernet so I can see the destination & source mac address.
The fpga works with a loop back etc.
The problem I have is when i connect it to a network card. The external network card does not recognize it.
I guess this is due to a layer 2 auto negotiation problem.
Is it possible to do a build with the pcs and pma ethernet module which allows me to filter based on source and destination mac? In addition will i get a strobe if it fails these values?
otherwise I'm forced to have to use the gt wizard and monitor the rxischar/rxiscomma signals until I get the correct sequence.
Now first things first.
How do I get an external network card to acknowledge there is a carrier?
Do I state machine a auto negotiation sequence or do I configure the network card?
REgards,
Wesley