Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to assign a short point (ideal ground) in CST transient

Status
Not open for further replies.

junsik

Junior Member level 2
Joined
Feb 17, 2015
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
207
Hi everyone!

In CST transient simulation, I have some question.
When I want to do transient simulation using CST, I want to assign one side of structure as a short point to the ideal ground.
It would make the low impedance current path to the ideal ground.

But, I don't know how to realize it.
there is some boundary condition. open, E=0, H=0, and so on...
When I simulate in frequency domain, i usually assign the open space as a boundary condition.
But, i understand it is not ground just adding vacuum in transient simulation. am i right?

Please help me. thank you.
 

volker@muehlhaus

Advanced Member level 5
Joined
Apr 11, 2014
Messages
2,511
Helped
983
Reputation
1,968
Reaction score
963
Trophy points
113
Activity points
14,884
Physically, there is no global ground. Ground is what you call ground, where you place your port's reference pin. However, even if you use PEC (perfect electric conductor) two points at some distance will have (and must have) delay and inductance between them.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top