Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How do I create Mouse Bites in Proteus?

Status
Not open for further replies.
C

chicowoodhill

Newbie level 4
Joined
Oct 19, 2006
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,350
I'm panelizing two independent circuit layouts in Proteus/Ares. I've figured out how to panelize the two PCB layouts on one board using the Ares Gerber Viewer, but I'm stumped on how to add slots and/or mouse bites so the boards can be separated after I receive them from the fab house.

So the question is, how to I create a routing slot or similar in the Proteus/Ares Gerber viewer? And how might I view the finished Gerber output to verify that the mouse bites are correctly implemented?

Thanks...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top