shiftregister 595 4094 vergleich
Hi,
Do not get so easily discouraged in life. Mr.Atferrari has been advising you to do it the right way, since the two chips are not directly compatible and the control signal levels are also different, the way you connect can differ as per your requirement.
Now, for 4094 , there is no MR-, so no worry.
The ST (Strobe) for 4094 is a latch enable signal and it controls a transparant latch, unlike the + edge used for 595. Also the OE signal is +ve for 494. So, if you are not worried about the intermediate values of the parallel output, you can tie both strobe and OE signals to a +ve pullp. In this case, after giving 8 pulses, you can read the parallel output keeping the clock low. Otherwise, just pull up OE signal and apply a +ve level to strobe input only when you want to read the shifted output. In the second case, the output will not change during the shifting process.
Any more doubts?, please come back.
With regards,