Hi,
These instruments with pulse output will mostly provide a pulse for fraction of KWH measured, which you can integrate by counting using for example a microcntroller and use in your application. The device thus can be used as a KWH sensor as well as a display unit for your cross verification if required.
Regards, Laktronics
Hi,
These instruments with pulse output will mostly provide a pulse for fraction of KWH measured, which you can integrate by counting using for example a microcntroller and use in your application. The device thus can be used as a KWH sensor as well as a display unit for your cross verification if required.
Regards, Laktronics
Hi,
The pulse output most likely will be voltage free contact or an opto output, which can be connected directly to a port pin of PIC , may be with a pull up resistor. The User manual of the device will specify all these.
Regards, Laktronics